Process gyroscope calibration for the following situations:
- The drone trembles significantly during hovering in GPS mode.
- The drone’s tilt range is too large during ascending in ATTI mode.
- The drone drifts during ascending or descending in GPS mode.
- The drone has been crashed or subjected to the heavy shaking.
- The remote controller screen prompts “WARNING Gyroscope error Calibrate Gyroscope”.
Note: When the drone is landing on the water, the remote controller may occasionally prompt “WARNING Gyroscope error Calibrate Gyroscope” and then disappear. Simply ignore the message when it does so. Gyroscope calibration on a boat or other moving platforms will not succeed. Please calibrate before boarding.
Place the drone on a level surface, power on the remote controller, then the drone. Wait for the aircraft to connect to the remote controller.
After the connection finishes, hold the left joystick down to its lowest position, then quickly move the right joystick left to right, back and forth, until the front and rear status indicators flash alternately, or the remote controller screen prompts “WARNING aircraft Initializing, Please Wait”. The drone will now perform gyroscope calibration. Now release the joysticks. This process will be completed in 20 seconds. Do not move the drone during this process.
When the front status indicators fast-flashing red and the rear status indicators turn solid green, or “WARNING Aircraft Initializing, Please Wait” prompt disappears, power off and restart the drone. Gyroscope calibration is complete. If the calibration fails, the “WARNING Aircraft Initializing, Please Wait” prompt will not disappear, please follow the steps, and try to calibrate again.
